2003 Saturn Ion 1 AutomaticFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Installation

  1. Use the retaining tab to secure the ECM when installing the ECM to the underhood junction block bracket.
  2. Connect the large ECM harness connector to the ECM. See Fig 1 .
  3. Connect the small ECM harness connector to the ECM.
  4. Connect the negative battery cable.
  5. Program the ECM. See ENGINE CONTROL MODULE REPROGRAMMINGΒ  .
Fig 1: Locating ECM Components
G00248334Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.