Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn Vue 3.0 BFACTORY OEM SERVICE PROCEDURE
Control Assembly: Installation
- Install control assembly and tighten bolts to 18 ft lbs. (25 N.m). See Fig 4 .
- Connect control assembly electrical connectors. Install indicator bulb by inserting and rotating 1/4 turn. See Fig 3 .
- Install park lock cable onto control assembly. Connect park lock cable onto control assembly pin. See Fig 2 . Install shifter cable onto control assembly. See Fig 1 .
- Secure with shifter cable retainer clip. Connect shifter cable onto control assembly pin.
- Install the console assembly. See CONSOLE ASSEMBLYΒ . Enable SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
