Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn Vue 2.2 D, AWDFACTORY OEM SERVICE PROCEDURE
Control Cable Assembly: Installation
- Route control cable through cable bracket. See Figure . Secure cable to bracket with control cable retainer clip. An audible snap will be heard when properly installed.
- With transaxle range switch lever located in Neutral position, snap cable end fitting onto ball stud of lever. An audible snap will be heard when properly installed. See Figure .
- Position vehicle on hoist and raise vehicle. Route cable along steering gear assembly into clip and up into dash panel. See Fig 2 .
- Lower the vehicle. Secure control cable grommet by pressing cable into pass-through hole in dash panel. See Fig 3 . Ensure gearshift lever assembly is in the Neutral position.
- Connect control cable to control assembly. Secure with control cable retainer clip. Install control cable onto control assembly lever. Adjust control cable assembly. See CONTROL CABLEΒ under ADJUSTMENTS.
- Install the console. See CONSOLE ASSEMBLYΒ . Install battery tray bracket and tighten bolts to 12 ft. lbs. (16 N.m). Install battery cooling box.
- Insert battery and tighten battery hold-down screw to 12 ft. lbs. (16 N.m). Connect battery cables. Install battery cooling box cover. Reprogram radio stations.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
