Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
There are 2 separate ignition module assemblies, one for each bank of cylinders. Each assembly contains an ignition control (IC) module and 4 ignition coils. Each IC module consists of the following circuits:
- The ignition 1 voltage
- A ground
- The IC timing low reference
- The IC control circuits for cylinders 1-8
Each ignition coil connects directly to its spark plug via a short boot. The IC control circuits transmit timing pulses from the powertrain control (PCM) module to the IC modules, which trigger the coils to fire the plugs in the correct sequence. The PCM monitors each IC control circuit for improper voltage levels.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.