Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn SC2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE
Removal & Installation: Generator: Removal
- Disconnect battery negative cable.
- Remove accessory belt.
- Raise and support vehicle on a hoist.
- Remove right wheel
- Remove right wheel well splash shield.
- Disconnect the field wires from generator.
- Disconnect fusible link wire using the Generator Output Stud Wrench (SA9401C) to hold the generator output (B+) stud from rotating.
- Remove lower and upper generator attachment bolts.
- Remove generator through the wheel well opening behind the strut.
NOTE:
Failure to hold stud when loosening the lock nut may crack the plastic insulator and cause generator to fail.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.