Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn SC2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE
DTC Parameters
- Engine speed is 1500-3000 RPM.
- Loop status is closed.
- Calculated airflow is greater than 7 grams per second.
- No CAM, CKP, ECT, EGR, EVAP purge solenoid, fuel trim, IAT, MAP, misfire, O2S1 or TP sensor DTCs are set.
DTC sets if ratio of O2S1 lean-to-rich average time to rich-to-lean average time is not 0.6-2.8 within a 100 second test.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.