Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn LW200 StandardFACTORY OEM SERVICE PROCEDURE
Control Assembly: Installation
WARNING: This page is about a different variant/trim than selected.
- Install control assembly into vehicle and install control assembly-to-floor pan bolts. See Fig 3 . Tighten control assembly to floor pan bolts to 71 INCH lbs. (8 N.m).
- Connect control assembly electrical connectors. See Fig 2 . Connect control cable to pin on control assembly. Secure control cable into control assembly by pushing into place.
- Install control cable retaining clip. See Fig 1 . Install console. See FLOOR CONSOLE . Enable the SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.