Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Saturn LW200 AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connectors to the instrument panel module (IPM) (1).
Install the IPM (1) to the instrument panel (IP) retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.
CAUTION: Refer to FASTENER NOTICE .

Fig 1: Connecting IPM Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Install the fastener.
Tighten

Tighten the fastener to 2 N.m (18 lb in).
Install the left sound insulator. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT -- LEFT .
Reprogram the IPM. Refer to Body Control Module (BCM) Programming/RPO Configuration (DIM) or Body Control Module (BCM) Programming/RPO Configuration (IPM) or Body Control Module (BCM) Programming/RPO Configuration (RIM) .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.