Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
If a TP sensor No. 1 or No. 2 DTC is set, diagnose that DTCs first. See DIAGNOSTIC TROUBLE CODE DEFINITIONSΒ .
If DTC P1523 is set, the ECM will default to one of the two limp home modes (random injector disable with engine speed limited to 1800 RPM). The REDUCED POWER telltale will be illuminated and the ECM will remain in this condition for the entire ignition cycle even if the fault is corrected.
The Throttle Body Relearn Procedure should be performed anytime a throttle body has been replaced or an ECM has been replaced or reprogrammed. See THROTTLE BODY RELEARN PROCEDUREΒ under PROGRAMMING.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
