Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Idle HC/Co Concentration Check
IMPORTANT:Β This check is used only to assist with idle HC/CO Diagnostics.
- Initial Conditions:
- Engine must reach normal operating temperature.
- Air cleaner installed.
- All pipes and hoses of air induction system connected.
- All vacuum lines properly connected.
- All fuel system wiring connections fully plugged.
- Transmission in P (Park) or N (Neutral) range.
- Tachometer and HC/CO meter calibrated and in hand.
- Run engine at 2500 RPM for approximately two minutes.
- Insert HC/CO meter testing probe into intermediate pipe at least 40 cm (16 in.).
- Check HC/CO concentration at idle.
IMPORTANT:Β Wait at least 1 minute before measuring to allow concentration to stabilize. Complete measuring within 3 minutes. If HC/CO concentration does not conform, see HC/CO DIAGNOSTIC CHARTΒ for possible causes.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
