Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Saturn L100FACTORY OEM SERVICE PROCEDURE
Body Control System Component Views
WARNING: This page is about a different car, the 2003 Saturn LW300, 2003 Saturn LW200, 2003 Saturn L300, and 2003 Saturn L200. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Radio |
| 2 | Right Heated Seat/Traction Switch |
| 3 | Hazard Switch |
| 4 | Left Heated Seat/Fog Lamp Switch |
| 5 | Passlock Sensor |
| 6 | Ambient Light Sensor |
| 7 | Ignition Lock Cylinder Solenoid |
| 8 | Windshield Wiper/Washer Switch |
| 9 | Ignition Switch C1 |
| 10 | Headlamp/Turn Signal Switch |
| 11 | Ignition Switch C2 |
| 12 | Inflatable Restraint Steering Wheel Module Coil C4 |
| 13 | Instrument Panel Cluster (IPC) |
| 14 | Dimmer/Rear Compartment Lid Release Switch |
| 15 | Wheel Speed Conditioner Module |
| 16 | Cruise/Brake Switch |
| 17 | Fuse Block - I/P - Left |
| 18 | C207 |
| 19 | Data Link Connector (DLC) |
| 20 | C215 |
| 21 | Accelerator Pedal Position (APP) Sensor |
| 22 | Cruise Control Module |
| 23 | C215 |
| 24 | C205 |
| 25 | I/P Compartment Lamp |
| 26 | Body Control Module (BCM) |
| 27 | C204 (w/o UE1) |
| 28 | C204 (w/ UE1) |
| 29 | Fuse Block - I/P - Right |
| 30 | C200 Body Harness Side |
| 31 | C200 Headliner Harness Side |
| 32 | Inflatable Restraint I/P Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
