Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
OnStar® Module Programming
New Vehicle
The OnStar® system requires no special programming from neither the Saturn Service Stall nor the Tech 2. All programming or customer profile setup is accomplished through the wireless connection to the OnStar® Cell center. In order to set up a customer account, simply press the OnStar® button located on the inside rear view mirror and respond the requests from the OnStar® advisor. The OnStar® call center will need personal information from the customer to activate the account. This information is provided after the vehicle is purchased.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
