2001 Saturn SW2 StandardFACTORY OEM SERVICE PROCEDURE

Code Enable Criteria

  • EVAP vent solenoid is commanded on (closed).
  • EVAP purge solenoid is commanded on (open).
  • Engine run time less than 10 minutes.
  • Fuel tank level 15-85 percent full.
  • BARO greater than 81 kPa.
  • Ignition voltage is 8-18 volts.
  • ECT and IAT at start-up are 41-90°F (5-32°C).
  • ECT and IAT within 50°F.
  • No ECT, fuel tank pressure, IAT, MAP or VSS DTCs are set.

DTC sets when 8 in. H2O cannot be pulled on EVAP system for greater than 3.2 seconds out of a 240 second cold engine test, indicating a large EVAP leak

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.