Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
PASS-Key® III System Quick Learn Procedure
NOTE:
PASS-Key® III system quick learn procedure is used to learn additional ignition keys (Black master or Gray valet). A learned Black master key must be used to initiate procedure. Up to 10 ignition keys can be learned.
- Using a previously learned master key (Black), turn ignition switch to ON position, engine off. Turn ignition switch to OFF position and remove the key.
- Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to ON position, engine off. Vehicle has now learned the new key.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.