Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
Code Enable Criteria
- EVAP vent solenoid is commanded on (closed).
- EVAP purge solenoid is commanded on (open).
- Engine run time less than 10 minutes.
- Fuel tank level 15-85 percent full.
- BARO greater than 81 kPa.
- Ignition voltage is 8-18 volts.
- ECT and IAT at start-up are 41-90°F (5-32°C).
- ECT and IAT within 50°F.
- No ECT, fuel tank pressure, IAT, MAP or VSS DTCs are set.
DTC sets when 8 in. H2O cannot be pulled on EVAP system for greater than 3.2 seconds out of a 240 second cold engine test, indicating a large EVAP leak
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
