Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0326: Knock Sensor System Performance: Description
Knock sensor is a piezoelectric device that produces an AC voltage of different amplitude and frequency based on engine mechanical vibration. Amplitude and frequency are dependent on level of mechanical vibration knock sensor detects. PCM learns a minimum noise level at idle from knock sensor and uses stored normal noise level calibration values for the rest of the RPM band. Knock sensor signal is only used during top dead center combustion event of firing cylinder. When in a combustion event, PCM filters knock signal and compares it to normal calibration noise level for that RPM. If PCM has determined that knock is present during combustion event, it will retard timing on next firing cylinders until knock is eliminated. PCM will always try to work back to a zero compensation level, or no spark retard. DTC sets when PCM cannot eliminate spark knock by retarding spark timing, which most likely is caused by engine noise.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
