Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
Open glove box door. Remove glove box light by pulling on plunger. Disconnect glove box light electrical connector. Set glove box light aside. Using flat-blade tool, remove lower right hush panel retainers. Pull lower right hush panel rearward to disengage from front retainers. Set hush panel aside. Remove lower right heater outlet duct. Remove glove box door screws and glove box door. Remove glove box-to-instrument panel screws. Slowly remove glove box, tilting downward to expose BCM, residing on top. Slide BCM out of retaining slots. Disconnect BCM electrical connectors. To install, reverse removal procedure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.