Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Manual Transaxle: General Description: Transaxle
The five-speed manual transaxle assembly consists of a differential unit and a constant-mesh design transaxle in a single case. All forward gears are in constant mesh. Synchronizers with blocker rings, controlled by shift forks, are used for ease of shifting and selection of the desired gear range. A sliding idler gear arrangement is used for reverse. All of the fundamental components, including aluminum transaxle case, aluminum clutch housing, input shaft, output shaft, and the differential assembly, are supported by ball and roller bearings. No pre-load of the bearings is required.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
