Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SW2 StandardFACTORY OEM SERVICE PROCEDURE
Vehicle Driveability Computer Relearn Procedure (M/T Models)
- If vehicle battery was disconnected or Powertrain Control Module (PCM) was replaced, turn ignition off. Reconnect PCM battery feed. Turn A/C off. Set parking brake and block drive wheels. Shift transmission into Neutral.
- Start engine. Idle engine until it reaches operating temperature. Allow engine to idle for 5 minutes. Turn engine off for 30 seconds. Vehicle should now be returned to learned idle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
