2000 Saturn SW2 StandardFACTORY OEM SERVICE PROCEDURE

DTC P1404: EGR Position Sensor Not Indicating Closed: Notes

EGR valve consists of a pintle valve that moves by the use of an internal solenoid and an internal position sensor used to determine pintle valve position. PCM controls solenoid by supplying ignition voltage whenever exhaust gas needs to be recirculated into intake manifold. PCM monitors EGR solenoid and position sensor circuits for correct voltage levels at certain times.

DTC will set if EGR solenoid is greater than 4 or 7.8 percent when EGR position is commanded to zero percent for greater than 20 seconds, engine speed less than 5000 RPM, EGR valve commanded to cycle greater than 61 percent 4 times and ignition voltage is greater than 11 volts.

NOTE: For circuit reference, see WIRING DIAGRAMS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.