2000 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE

Procedure For Normal Operation

  1. Start engine and operate vehicle for 15 miles, 15 minutes or until a normal transaxle operating temperature of 190-200Β°F (88-93Β°C) is reached. Park vehicle on level ground and apply parking brake. Move gear selector through all gear positions, ending in Park. Let vehicle idle for 3 minutes with accessories off.
  2. With the engine running, pull out dipstick and wipe it off with a clean rag or paper towel. Push dipstick back in all the way, and then immediately pull it back out. Check both sides of dipstick, and read the lower level. Transmission fluid level must be in the cross-hatched area. See Fig 1 . There may be some spatters of transmission fluid on dipstick above transmission fluid level. This is normal.
  3. If transmission fluid level is in cross-hatched area on dipstick, push dipstick back in all the way. If transmission fluid level is below the "ADD" mark, then add only enough Saturn Transaxle Fluid to bring transmission fluid level up into cross-hatched area. When transmission fluid level is at the "ADD" mark it will take approximately 0.5 qts. to bring transmission fluid level up to normal operating range.
Fig 1: Checking Transmission Fluid Level
G00072783Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.