Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
System Operation Check
WARNING: This page is about a different car, the 2000 Chevrolet Corvette, 1999 Chevrolet Corvette, and 1998 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Move mirror select switch to left mirror position. Operate left mirror to left, right, up and down positions. Mirror should operate as commanded in all positions.
- Move mirror select switch to right mirror position. Operate right mirror to left, right, up and down positions. Mirror should operate as commanded in all positions.
- To check memory mirror function, press memory No. 1 button. A single beep should be heard, and both mirrors should move to positions programmed for memory No. 1 button.
- Press memory No. 2 button. A single beep should be heard, and both mirrors should move to positions programmed for memory No. 2 button.
- If mirror system does not function properly, repair by symptom. See SYMPTOM INDEX table under SYMPTOM TESTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.