Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
System Tests: Notes
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For additional information on vehicles equipped with memory, go to MEMORY SYSTEMS - CORVETTE
article.
SYMPTOM INDEX
| Symptom | Perform Test |
|---|---|
| Driver's Seat Inoperative (Without Memory) | 1 |
| Passenger's Seat Inoperative | 2 |
| Seat Does Not Move Forward/Rearward | 3 |
| Seat Does Not Tilt Forward | 4 |
| Seat Does Not Tilt Rearward | 5 |
| Lumbar Inoperative (Both Seats) | 6 |
| Lumbar Inoperative (Driver's Seat) | 7 |
| Lumbar Inoperative (Passenger's Seat) | 8 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.