Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
Muffler (Service Replacement): Installation
- Loosely install muffler clamp over service replacement muffler inlet.
- Load replacement muffler to vehicle, sliding muffler inlet pipe over cut section of intermediate pipe.
- Hold muffler in location to muffler strap and tighten clamp. Locate muffler strap between stamped channel in the muffler.
Torque:
Muffler Strap around Muffler: 22 N.m (16 ft-lbs)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.