Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSREMOVAL & INSTALLATIONPARK LOCK CABLEINSTALLATION
2000 Saturn SL2 Automatic, MP6
Park Lock Cable: Installation
2000 Saturn SL2 Automatic, MP6SECTION Installation
- Install the new park lock cable. See Fig 5 . Route cable around HVAC module fin.
- Route cable through accelerator pedal bracket retainer clip. See Fig 6 .
- Install park lock cable fitting end to control base assembly. See Fig 4 . Ensure to seat fitting completely. Attach park lock cable end terminal to plastic lock-out lever on the control assembly.
- Snap park lock cable assembly onto ignition module. See Fig 7 . Install lower column cover, top column cover, and fasteners. Install ignition switch bezel. See Fig 1 .
- Align peg of ignition bezel with cut-out in lower shroud. Snap into place.
- Adjust the park lock cable assembly. See PARK LOCK CABLE under ADJUSTMENTS. Install console. See FLOOR CONSOLE . Enable the SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
NOTE:
The ignition key must be in the ACC position when installing the ignition cylinder into the ignition module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.