Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSREMOVAL & INSTALLATIONFLOOR CONSOLEREMOVAL
2000 Saturn SL2 Automatic, MP6
Floor Console: Removal
2000 Saturn SL2 Automatic, MP6SECTION Removal
- Disable SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION. Apply parking brake lever.
- Remove window/mirror switch, if equipped. Exert pressure on rear of switch with hand. Pry up with blunt tool at rear retainer assembly tabs. See Figure . Lift window/mirror switch up and out.
- Disconnect electrical connector by locating retention tabs and disengaging connectors. See Figure . Adjust front seats to forward most position.
- Remove rear console screws. See Figure . Adjust front seats to rearward most position. Remove left and right lower trim panel extensions by pulling outward at dual lock locations. See Figure .
- Rotate panels outward to disengage hinges from console. Remove front console screws. See Figure . Move console rearward.
- Disengage retaining tabs and disconnect power outlet connector. See Figure . Press and place tape on gear selector button into clear shifter opening.
- Maneuver console beyond gear selector and parking brake by lifting rear of console. Remove console from vehicle. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.