SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSREMOVAL & INSTALLATIONFLOOR CONSOLEINSTALLATION
2000 Saturn SL2 Automatic, MP6

Floor Console: Installation

2000 Saturn SL2 Automatic, MP6SECTION Installation
  1. Apply park brake. Adjust front seats to most rearward position. Recline driver's and passenger's seat backs as far down as possible.
  2. Hold front end of console down and rear end up. Position all harnesses so they can be accessed. See Fig 6 .
  3. Maneuver console over gear selector lever and past brake lever.
  4. Connect power outlet electrical connector. Remove tape from gear selector. Install rear console screws and tighten to 19 INCH lbs. (2.2 N.m). See Fig 3 .
  5. Install front console screws and tighten to 19 INCH lbs. (2.2 N.m). Install left and right extension panels by inserting hinges into console. See Fig 4 .
  6. Rotate closed and push in at dual lock locations. Install window/mirror switch. Enable SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Fig 1: Releasing Window/Mirror Switch Retainers
G00082476Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.