Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SL2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE
Fuel Tank Pressure Sensor: Installation
NOTE:
To facilitate installation of the tank pressure sensor into its mounting boss on the fuel tank, lightly lubricate the multi-ribbed seal on the tank pressure sensor. A drop of clean engine oil is sufficient.
- Install tank pressure sensor into the fuel tank mounting boss.
- Latch the retaining arm of the mounting bracket over the tank pressure sensor and insure that the connector end is located between the uprights on the mounting pad.
- Install fuel tank and fuel filler pipe. Refer to FUEL TANK .
- Perform the "Service Bay Diagnostic Test" for the evaporative emission system using the Scan tool. This test will verify the integrity of the vapor handling areas of the fuel system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.