Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SL2 AUTOMATIC, MP6REPAIR AND DIAGNOSISENGINE MECHANICALENGINE EXHAUST SYSTEMREMOVAL AND INSTALLATIONINTERMEDIATE PIPE (SERVICE REPLACEMENT)REMOVAL
2000 Saturn SL2 Automatic, MP6
Intermediate Pipe (Service Replacement): Removal
2000 Saturn SL2 Automatic, MP6SECTION Removal
NOTE:
If both the intermediate pipe and muffler assembly are being replaced, the intermediate pipe must be shortened at the outlet end so the muffler inlet can fit over it. Cut the intermediate pipe right behind the up-sized outlet end.
- Raise vehicle squarely on a lift.
- Remove nuts at the outlet of the catalytic converter to intermediate pipe.
- Remove catalytic converter gasket and discard.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.