Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
2000 Saturn SL2 Automatic, MP6SECTION Removal & Installation
- Turn ignition off. Remove air cleaner housing cover and air induction hose at throttle body. Remove PCM mounting bolts, harness connector and remove PCM from carrier. PCM is located near left front strut tower.
- Clean ABS control module external surfaces with brake cleaner. Disconnect harness connector from module. Remove ABS control module-to-BPMV mounting screws. Pull module straight out of valve assembly.
- To install, reverse removal procedure. Ensure pins are properly aligned between module and BPMV. Ensure gasket is not damaged. Use Loctite 5900(tm) to repair damaged gasket areas. Replace control module if gasket damage is 5/8" or larger. Tighten all mounting screws to specifications. See TORQUE SPECIFICATIONS table.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.