Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
2000 Saturn SL
Manual Transmission Clutches
2000 Saturn SLSECTION Manual Transmission Clutches
- General Diagnostic Information
- Diagnostics
- General Description
- Clutch System Removal And Installation
- Manual Transaxle Removal And Installation
- Notes
- General Service Information
- Air Cleaner Housing And Duct Assembly
- Console
- Control Lever Boot Assembly (On-Vehicle)
- Shifter Control Assembly (On-Vehicle)
- Shift/Selector Cable (On-Vehicle)
- Vehicle Speed Sensor (On-Vehicle)
- Back-Up Lamp Switch (On-Vehicle)
- Shift Control Housing (On-Vehicle)
- Transaxle Fluid Changing Procedure (On-Vehicle)
- Left Side Axle Seal (On-Vehicle)
- Right Side Axle Seal (On-Vehicle)
- End Cover (On-Vehicle)
- 5th GEAR AND 5th/REVERSE SYNCHRONIZER ASSEMBLY (ON-VEHICLE)
- Transaxle Removal
- Transaxle Disassembly/Assembly
- Notes
- Transaxle Disassemble
- Differential Disassembly
- Differential Assembly
- Output Shaft Roller Bearing Removal
- Input Shaft Roller (Quill) Bearing Removal
- Output Shaft Disassembly
- Output Shaft Assembly
- Output Shaft Clearance Measurement
- Gear Synchronizer Blocker Ring Inspection
- Input Shaft Disassembly
- Input Shaft Assembly
- Input Shaft Clearance Measurement
- Transaxle Assemble
- Transaxle Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.