Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SLFACTORY OEM SERVICE PROCEDURE
"L" Series
- Remove and discard rear axle control arm bolts. Install NEW rear axle control arm bolts, but do not tighten at this time. Leave inside forward bolt out. Install Rear Alignment Tool (KM 900) into open bolt hole.
- Using alignment tool, move rear axle control arm in direction necessary for toe correction. Snug rear axle control arm bolts, but do not tighten to final torque at this time. Recheck toe and readjust as necessary. Tighten bolts to specifications. See TORQUE SPECIFICATIONS . Repeat procedure for other rear wheel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.