Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SLFACTORY OEM SERVICE PROCEDURE
Seed & Key Method
NOTE:
Seed & key method takes 10 minutes to perform.
- Check BCM and PCM for existing DTCs. If DTCs exist, repair as necessary and go to next step. If no DTCs exist, go to next step.
- Install scan tool. Turn ignition switch to RUN position. Using scan tool in PROGRAMMING SYSTEM mode, select PASSLOCK RELEARN procedure. Wait 10 minutes. When SECURITY indicator light changes from a flashing or on state to an off state, turn ignition switch to OFF position. Vehicle should start on next ignition cycle.
NOTE:
If ignition switch is turned to OFF position before SECURITY indicator light changes state, relearn procedure must be restarted.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.