Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing Diagnostic Trouble Codes
DTCs can be cleared using scan tool. If scan tool is not available, turn ignition switch to OFF position. Remove PCM/IGN fuse (10-amp) from fuse block for 30 seconds. Replace fuse. If fuse cannot be located, disconnect PCM pigtail at battery for 30 seconds. DTCs may also be cleared by disconnecting negative battery cable. However, this may result in loss of other on-board memory data, such as preset radio tuning. After power to PCM is removed, poor driveability may occur until control module relearns operating parameters.
DTCs will also be cleared under the following conditions:
- PCM will turn off MIL after 3 consecutive ignition cycles without a failure reported.
- PCM will cancel DTC default actions when fault no longer exists, and ignition is cycled off long enough to power down PCM.
- DTC is cleared when vehicle has achieved 40 warm-up cycles without a failure reported.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.