Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSSHIFT INTERLOCK SYSTEMSREMOVAL & INSTALLATIONPARK LOCK CABLEREMOVAL
2000 Saturn SC2 Automatic, MP6
Park Lock Cable: Removal
2000 Saturn SC2 Automatic, MP6SECTION Removal
- Disable the SIR System. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION. Remove console. See FLOOR CONSOLE .
- Use a small screwdriver to gently pry ignition switch bezel from lower column cover. See Figure . Remove lower column cover fasteners, upper cover, and lower cover. See Figure .
- Disengage the retaining tabs and remove the park lock cable assembly from the ignition module. See Figure . Disconnect the end terminal of the park lock cable assembly from the plastic lock-out lever at the control base assembly.
- Depress 2 tabs on the end fitting of the park lock cable assembly and remove the park lock cable assembly from the control base assembly. See Figure .
- Remove park lock cable assembly from vehicle. See Figure . Note cable routing. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.