Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn SC2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE
Floor Console: Installation
- Apply park brake. Adjust front seats to most rearward position. Recline driver's and passenger's seat backs as far down as possible.
- Hold front end of console down and rear end up. Position all harnesses so they can be accessed. See Fig 6 .
- Maneuver console over gear selector lever and past brake lever.
- Connect power outlet electrical connector. Remove tape from gear selector. Install rear console screws and tighten to 19 INCH lbs. (2.2 N.m). See Fig 3 .
- Install front console screws and tighten to 19 INCH lbs. (2.2 N.m). Install left and right extension panels by inserting hinges into console. See Fig 4 .
- Rotate closed and push in at dual lock locations. Install window/mirror switch. Enable SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.