Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISENGINE MECHANICALENGINE EXHAUST SYSTEMREMOVAL AND INSTALLATIONINTERMEDIATE PIPE (SERVICE REPLACEMENT)INSTALLATION
2000 Saturn SC2 Automatic, MP6
Intermediate Pipe (Service Replacement): Installation
2000 Saturn SC2 Automatic, MP6SECTION Installation
- Position service intermediate pipe under vehicle.
- Slide outlet end of intermediate pipe over remaining section of muffler inlet pipe.
- Install new gasket at outlet of catalytic converter.
- Install intermediate pipe to converter outlet using three fasteners.
Torque:
Intermediate Pipe-to-Converter Nuts: 25 N.m (19 ft-lbs)
- Install rubber isolator to hanger rod on intermediate pipe.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.