Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSISELECTRICALSTARTERSTARTING SYSTEMREMOVAL & INSTALLATIONTRANSAXLE RANGE SWITCHINSTALLATION
2000 Saturn SC2 Automatic, MP6
Transaxle Range Switch: Installation
2000 Saturn SC2 Automatic, MP6SECTION Installation
- Install the switch to the transaxle and install the switch-to case bolts. Do not tighten bolts at this time.
- Install the control lever-to-manual shift shaft.
- Prevent the manual shift shaft from rotating by holding the control lever while installing the retaining nut. Tighten to specifications. See TORQUE SPECIFICATIONS .
- Install the cable to the control lever and adjust the cable. See SHIFT CABLE under ADJUSTMENTS in appropriate SERVICING - A/T article in AUTOMATIC TRANSMISSION.
- Before tightening the transaxle range switch-to-case bolts, proceed to the adjustment procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.