2000 Saturn SC2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE

Hydraulic System Bleeding

NOTE: If air was allowed into hydraulic system during servicing, bleed system. Aerated fluid, which is Light Tan in color, results in poor steering performance and causes pump damage.
  1. Turn ignition off. Raise and support front of vehicle with wheels off ground. Turn wheels fully to left. Check fluid level. If necessary, add power steering fluid to FULL mark on fluid level indicator. Turn wheels from side to side several times, but DO NOT touch steering stops. Add fluid, if necessary, to maintain level at FULL mark.
  2. Start engine. With engine idling, check fluid, and add as necessary. Return wheels to center position. Lower vehicle. Continue to run engine for 2-3 minutes to bring fluid to operating temperature.
  3. Road test vehicle. Check for leaks. Ensure fluid level is at FULL mark when fluid stabilizes at operating temperature.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.