Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Feedback
On some models, the fuel pump circuit between the fuel pump relay and fuel pump is monitored by PCM. This enables PCM to determine when the fuel pump relay is energized and voltage is being delivered to fuel pump. Voltage monitored on this circuit is also used in calculations to determine changes in idle speed, air/fuel ratio and ignition dwell. Failure in this monitored circuit should set a related diagnostic trouble code.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.