2000 Saturn SC2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE

MULTIFUNCTION Switch: Removal

  1. Set front wheels in straight-ahead position. Before proceeding, disable air bag system. See appropriate AIR BAG RESTRAINT SYSTEMS article. Turn ignition switch to LOCK position. Remove air bag module and steering wheel. See STEERING WHEEL  .
  2. Remove SIR coil assembly. See appropriate AIR BAG RESTRAINT SYSTEMS article. Remove Data Link Connector (DLC) screws. Pull steering column filler panel forward and set down. Disconnect hood release cable. Pull hood release handle forward, remove cable, and slide pin out.
  3. Remove steering column filler panel. Disconnect multifunction switch connectors. See Fig 1 . Remove multifunction switch assembly.
  4. To install, reverse removal procedure. Tighten screws to specification. See TORQUE SPECIFICATIONS  .
Fig 1: Removing Multifunction Switch Assembly
G95C35131Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.