Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000SC2 AUTOMATIC, MP6REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSSYSTEM TESTSNOTES
2000 Saturn SC2 Automatic, MP6
System Tests: Notes
2000 Saturn SC2 Automatic, MP6SECTION Notes
NOTE:
On 2000 models, wiper motor control module is integral to wiper motor. On 2001 models, wiper motor control module was a separate component. When directed to replace wiper motor/control module on 2001 models, replace control module. Retest system and if fault still occurs, replace wiper motor. For wire color, component connector, circuit and terminal identification, see WIRING DIAGRAMS .
SYMPTOM INDEX
| Symptom | Perform Test | ||||
|---|---|---|---|---|---|
| Front Wiper Motor Inoperative In Any Mode, Washer Inoperative | A | ||||
| Front Wiper Motor Inoperative With Switch In High Position Only | B | ||||
| Front Wiper Motor Operates In High Speed Only | C | ||||
| Wiper Motor Operates In INT Position Only | (1) | ||||
| Wiper Motor Inoperative In MIST Position Only | (1) | ||||
| Wipers Stop, Then Restart After Several Minutes | (2) | ||||
| Front Washer Pump Inoperative, Wiper Motor Operates | D | ||||
| Rear Wiper Motor Inoperative | E | ||||
| Rear Wiper Motor & Washer Pump Inoperative | F | ||||
| Rear Washer Pump Inoperative, Rear Wiper Motor Operates Normally | G | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.