2000 Saturn SC1 AutomaticFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove TAC module. See THROTTLE ACTUATOR CONTROL (TAC) MODULEΒ  . Loosen, but do not remove rear PCM retaining fastener. Use rear fastener as an anchor for outer bracket.
  2. Remove front PCM retaining fastener. Reposition PCM outer bracket. Remove PCM from bracket and extract from vehicle. To install, reverse removal procedure. After installation, perform computer relearn procedure. See COMPUTER RELEARN PROCEDURES -- GENERAL MOTORS article in GENERAL INFORMATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.