Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Control Module: Service and Repair
2000 Saturn LW2 V6-3.0L VIN RSECTION Service and Repair
REMOVAL
1. Turn ignition Off.
2. Disconnect J1 and J2 ECM electrical connectors.
3. Remove ECM bolts.
4. Remove ECM.
INSTALLATION
1. Install ECM.
2. Install ECM bolts.
Torque: 8 N.m (71 in-lbs)
3. Connect J1 and J2 ECM electrical connectors.
4. Program ECM by following directions. Programming and Relearning
5. Learn Passlock password by following directions. Programming and Relearning
6. Turn Ignition On, Engine Off for 1 minute to learn throttle position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.