Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW2 V6-3.0L VIN RREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSPECIFICATIONSRIDE/TRIM HEIGHT SPECIFICATIONS
2000 Saturn LW2 V6-3.0L VIN R
Ride/Trim Height Specifications
2000 Saturn LW2 V6-3.0L VIN RSECTION Ride/Trim Height Specifications
BUMPER HEIGHTS
IMPORTANT: When measuring alignment angles, it is critical that the vehicle bumper height be correct. Measure and adjust bumper height according to the following procedure before performing alignment.
1. Place vehicle on a level surface.
2. Adjust tire pressures to correct specifications.
Curb bumper height should be measured with:
- 207 kPa (30 psi) tire pressure - front tires
- 207 kPa (30 psi) tire pressure - rear tires
3. If vehicle fuel tank is not full, the following chart may he used to determine amount of weight necessary to be added to the trunk of vehicle to simulate a full fuel tank.
4. Bounce front and rear of vehicle a few times to settle suspension.
5. Measure front and rear vehicle curb trim height.
Locating point -Y and +Y is distance from the center line of vehicle according to the following chart.
Measure curb bumper height from ground to bottom horizontal surface of bumper.
IMPORTANT: When measuring alignment angles, it is critical that the vehicle bumper height be correct. Measure and adjust bumper height according to the following procedure before performing alignment.
1. Place vehicle on a level surface.
2. Adjust tire pressures to correct specifications.
Curb bumper height should be measured with:
- 207 kPa (30 psi) tire pressure - front tires
- 207 kPa (30 psi) tire pressure - rear tires
3. If vehicle fuel tank is not full, the following chart may he used to determine amount of weight necessary to be added to the trunk of vehicle to simulate a full fuel tank.
4. Bounce front and rear of vehicle a few times to settle suspension.
5. Measure front and rear vehicle curb trim height.
Locating point -Y and +Y is distance from the center line of vehicle according to the following chart.
Measure curb bumper height from ground to bottom horizontal surface of bumper.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.