Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW2 AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (ANTI-THEFT SYSTEM)PROGRAMMINGBCM/PASS-KEY(R)
2000 Saturn LW2 Automatic
Section 5 (Anti-Theft System): Programming: BCM/Pass-Key(R)
2000 Saturn LW2 AutomaticSECTION BCM/Pass-Key(R)
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Performing the following procedure will set DTC P1630. This is normal. After procedure is completed, turn ignition off for 30 seconds. Turn ignition on. DTC P1630 should clear. If DTC does not clear, see appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.