Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transaxle Position Switch (A/T) Test
Disconnect transaxle position switch Gray 7-pin connector on "L" series, or Gray 2-pin connector on "S" series. Transaxle position switch is located on top of transaxle, between transaxle and shift linkage. See Fig 2 . On "L" series, connect a fused jumper wire between transaxle position switch harness connector terminals "E" and "G". See Fig 1 . On "S" series, connect a fused jumper wire between transaxle position switch harness connector terminals. On all models, turn ignition switch to START position. If engine cranks, replace transaxle position switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.