Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW2 AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXANTI-LOCK BRAKE/TCS DTCS
2000 Saturn LW2 Automatic
Anti-Lock Brake/TCS DTCS
2000 Saturn LW2 AutomaticSECTION Anti-Lock Brake/TCS DTCS
ANTI-LOCK BRAKE/TCS DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| C0035 | Left Front Wheel Speed Sensor Malfunction - No Signal/Invalid Signal |
| C0040 | Right Front Wheel Speed Sensor Malfunction - No Signal/Invalid Signal |
| C0045 | Left Rear Wheel Speed Sensor Malfunction - No Signal/Invalid Signal |
| C0050 | Right Rear Wheel Speed Sensor Malfunction - No Signal/Invalid Signal |
| C0060, C0065, C0070, C0075, C0080, C0085, C0090 & C0095 | ABS Solenoid Circuit Malfunction |
| C0110 | Pump Motor Malfunction |
| C0121 | Valve Relay Circuit Malfunction |
| C0141, C0146, C0151 & C0156 | TCS Solenoid Circuit Malfunction |
| C0161 | ABS/TCS Brake Switch Circuit Malfunction |
| C0236 | TCS RPM Signal Circuit Malfunction |
| C0241 | PWM Delivered Torque Reduction Malfunction |
| C0244 | PWM Delivered Torque Malfunction |
| C0245 | Wheel Speed Sensor Frequency Error |
| C0550 | ECU Malfunction |
| C0551 | Option Configuration Error |
| C0896 | System Voltage High/Low |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.