Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Lighting
2000 Saturn LW1 L4-2.2L VIN FSECTION Lighting
Circuit Chart:
CIRCUIT CHART
Circuit assignments for the body control module (BCM) relating to lighting:
DISPLAY DIMMING
Display dimming is controlled by the BCM based on input received from the dimming potentiometer. The dimming potentiometer is connected between circuit 1359 and circuit 1381. The BCM monitors these inputs and provides a Pulse Width Modulated (PWM) output at circuit eight to operate the display lamps.
PARK LAMP SWITCH
The BCM compares the state of the park lamp circuit nine to the high beam headlamp circuit 1200 and the low beam headlamp circuit 1201.
If the park lamp circuit is grounded/open and either the low beam circuit is at battery voltage or the high beam circuit is grounded, DTC B2662 - Parklamp Switch Circuit Malfunction will set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.