Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LW1 AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (POWER WINDOW SYSTEM)COMPONENT LOCATIONS
2000 Saturn LW1 Automatic
Component Locations
2000 Saturn LW1 AutomaticSECTION Component Locations
WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Body Control Module | Right Footwell, Mounted To Floor Board Behind Carpet |
| Data Link Connector | Left Side Of Instrument Panel, Below Steering Column |
| Door Control Module (DCM) | Behind Bottom Center Of Door Trim Panel |
| Instrument Panel Electrical Center | Right Footwell, Mounted To Floor Board Behind Carpet |
| Underhood Electrical Center | Right Rear Corner Of Engine Compartment, Between Battery & Coolant Reservoir |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.